| to all interested parties of the Camping-up will be presented once more detailed on this page. The numerous images can lead to longer loading times. Construction | | is a wooden rack in the trunk of the skeleton of the structure. It consists of wood sections of the 50/30 starch is about 40cm high and is fixed with straps at fixed points in the back seat and the sill. The frame is covered by the rear 15mm OSB board, OSB board, the average is only about a page. 7-8cm on. The other side lies on the edge of the folded down back seats, this was an even 10cm high wooden profile below the height adjustment screw to the plate. The plate is also anchored to the vehicle ground strap back. The third front plate with hinges at the Second fixed and can be folded down the seats to bring in the driving position to be able to. When unfolded it is to the left and right supported 24/48mm with a wooden template. These are locked down in the track of the front seat. The mattress | The trunk of the Corsa before folding down the rear bench seat, the seat and the rear seats removed The base frame with permanently integrated sink and serves as base for the mattress The frame is secured in the trunk with straps at fixed points in the car full use of space - just fits so! ;) full use of space - just fits so! ;) After installation, the containers are easily adjusted, the frame is so large that the canister simply The mattress clamp in the folded state, the gap is an edge on the back of the rear bench seat placed The mattress will use straps fixed so that the situation is under stress does not change The room can under the mattress room for the mattress and 2 camping stoves installed The mattress built the deck area in the folded and ready to drive built the deck area in the folded and ready to drive built the deck area in the folded and ready to drive as a bed, we use target="_blank"> baby mattresses . These are 1,20 x0, 60m high, divided into three parts and comes with a handy carrying case The mattress in the completely unfolded state The mattress in the completely unfolded state The mattress in the completely unfolded state The mattresses fit almost perfectly on the 1.80 m x1, 20m area of usable open space is 1.45 m x 2,00 m The mattresses fit almost perfectly on the 1.80 m x1, 20m area of usable open space is 1.45 m x 2,00 m The kitchen The frame is recessed a sink ... ... which is powered from a 12V electric water pump with water. The water tanks each hold 12Liter. In the fresh water line, a return valve is installed, the water can thus only flow in one direction. The wastewater flows by the large spiral pipe to the waste water tank, the line is secured by Schauchschelle. The yellow valve serves to vent so that water can flow properly. In the rest of the frame are the gas heater, gas lamp and the sides of the table. The table The rear panel can be plugged into the base and used as a table. The rear panel can be plugged into the base and used as a table. The wooden structure is used to enlarge the table. The rear panel can be plugged into the base and used as a table. Additional plates can thus be placed on the left and right. |
0 comments:
Post a Comment